No sub-out from receiver.

[mitro]

Is it best to run the L/R signal to the Ventriloquist center first and then to the sub and then to the satellites?
Or is it better to run the L/R signal to the sub frst, then the VT-12, and then to the satellites?

It seems like the sub should get first crack at the signal, but I may be mistaken.

Thanks,
--john--

[wid]

It should be ran to sub first and set the crossover to 80hz mark on the sub.Be aware the crossover on the sub might not be exact so you might want to use a set up disk to get the sub right about the correct setting.If your recievier has pre outs you could also use them instead.You would then have to split the signal to the sub then back to the reciever.Either way will be fine. Good luck.