tlabatte
June 20th, 2008, 3:10 PM
Newbie here....
I have a room that is 13 x 26 x 8 Feet. I am almost ready to install the components to make this room a HT (13x13) and the rest a little table area with a wetbar (in the back 13 feet). There is an opening to another room that is 3.5 feet wide and opens up to a small foyer that is approx 10x10x8.
I have already installed Speakercraft in-wall speakers:
AIM LCR3 Three - Left, Center, Right
AIM Cinema Dipole One - Side Surround
AIM5 One (Ceiling) - Rear Surround
These are basically 80 watt speakers
I plan to power this set-up with the new Onkyo SR 606. Blue Ray will be the Panasonic BD30. TV will be a Panasonic 58" Plasma (either the 700 or 750)
Assuming I ignore the other room, the VTF-1 should be more than enough to power the room. Based on what I read, I will most definately want to use the extended mode exclusively.
Are my assumptions correct?
I have a room that is 13 x 26 x 8 Feet. I am almost ready to install the components to make this room a HT (13x13) and the rest a little table area with a wetbar (in the back 13 feet). There is an opening to another room that is 3.5 feet wide and opens up to a small foyer that is approx 10x10x8.
I have already installed Speakercraft in-wall speakers:
AIM LCR3 Three - Left, Center, Right
AIM Cinema Dipole One - Side Surround
AIM5 One (Ceiling) - Rear Surround
These are basically 80 watt speakers
I plan to power this set-up with the new Onkyo SR 606. Blue Ray will be the Panasonic BD30. TV will be a Panasonic 58" Plasma (either the 700 or 750)
Assuming I ignore the other room, the VTF-1 should be more than enough to power the room. Based on what I read, I will most definately want to use the extended mode exclusively.
Are my assumptions correct?