View Single Post
  #22  
Old December 2nd, 2004, 11:26 AM
jbug jbug is offline
Registered User
 
Member Since: Nov 2004
Posts: 49
jbug is on a distinguished road
Just received the speaker stands from partsexpress. The clamps are a wee bit too wide for the sats. Did I get the right ones? Do I need to pad them with something? There are some velcro pads that came with the stands, but do not seem to fit the bil for padding.
http://www.partsexpress.com/pe/show...tnumber=240-762

Same here, the clamps don't come in far enough to firmly hold the little speaker. I bridged the gap on both sides by using a solid (round) vacum cleaner belt that I cut into 4 pieces. I'm sure if you look around the house, you will find even better material to fill in the gaps. I am surprised that no one else is mentioning this problem.
Reply With Quote