View Single Post
  #3  
Old February 9th, 2019, 10:12 AM
glassetcher glassetcher is offline
Registered User
 
Member Since: Oct 2015
Posts: 11
glassetcher is on a distinguished road
Quote:
Originally Posted by Kevin_Hsu View Post
Hi there,

Possibly, but sometimes the LFE can still introduce a high impedance signal that may actually end up causing a large volume drop when you play your 2 channel setup. That can also be a bit messy in terms of material delivered from potentially two difference sources. My recommendation would be to run XLR from your Setllar Gain Cell preamp to your S300 (if you are not already). Then I would run the RCA preouts from your Stellar Gain Audio and the LFE (subwoofer) preouts from the Denon 4300 to a RCA switch box. From the RCA switch box, you can run that to the STF-2 and VTF-2 Mk5. That way you can select that source that you want to go to the sub. When you use your 2 channel stereo only setup, you also want to set the crossover to in on both subs as well. For HT, you can set them to out because the denon has a built in crossover for you.
Kevin, thanks for getting back to me.
So, can the subs still process the LFE signal going from the RCA switch box into their high level inputs the same as if the LFE signal was going to the LFE input? What is the difference in the high level speaker signal and the LFE signal from the receiver?
Reply With Quote