![]() |
#1
|
|||
|
|||
ULS-15 rear panel questions
Can someone educate me on the following settings.
ULF trim. Currently set to 16hz Crossover out/in Currently set to out. I have a Onkyo 5010 many thanks |
#2
|
|||
|
|||
The ULF Trim boosts the deep bass output. The deeper the frequency it is set to, the more of a boost the deep bass gets. If you like to listen to movies at loud volumes, it might be a good idea to keep this higher, closer to 50 Hz.
The crossover switch will let the ULS-15 run full range if it is set to 'out'. If it is set to 'out', it is up to the AVR to filter out high frequencies. I would set it to 'out' and let the Onkyo deal with the crossover. |
#3
|
|||
|
|||
thank you for the response Shadyj
|
![]() |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Thread Tools | |
Display Modes | Rate This Thread |
|
|